Atec Agilent-DSA90404A - Manual (Page 8)

8
Debug your toughest designs with confidence
InfiniiScan event identification (N5414B or Option 009 on new scope purchases)
Rapidly trigger on complex events and identify signal integrity issues. This innovative
software quickly scans through thousands of acquired waveform cycles and isolates
anomalous signal behavior.
This application is supported on all models.
For more information: www.agilent.com/find/infiniiScan
Identify signal integrity issues with InfiniiScan
Zone – Qualify triggering.
High-speed serial data analysis software (E2688A or Option 003 on new scope
purchases)
Quickly validate signal integrity for high-speed serial interfaces with embedded clocks.
Recover embedded clocks synchronized with the analog waveform view. Build and
validate eye diagrams.
The SDA package also includes software-based bit-level triggering and decode for
8B/10B. This application is supported on all models and comes standard on DSA
models.
For more information: www.agilent.com/find/SDA
Recover embedded clocks with serial data
analysis (SDA).
PrecisionProbe software (N2809A or Option 001 on new scope purchases)
Make more accurate measurements independent of what probes or cables used.
Agilent’s N2809A PrecisionProbe software characterizes and corrects for the loss
in your specific cable or probe. PrecisionProbe removes the uncertainty about the
input connected to your oscilloscope by allowing you to see its characteristics in
less than five minute. PrecisionProbe gives you design and debug confidence by
allowing you to quickly de-embed probe and cable loss to make more accurate
measurements.
For more information: www.agilent.com/find/PrecisionProbe
Quickly characterize and correct for any input
to your oscilloscope.