Atec Agilent-E5062A - Manual (Page 20)

20
Measurement capabilities
Source control
Number of measurement channels Up to 4 independent measurement channels. A measurement channel is coupled
to stimulus response settings including frequency, IF bandwidth, power level,
and number of points.
Number of display windows Each measurement channel has a display window. Up to 4 display windows (channels)
can be displayed.
Number of traces 4 data traces and 4 memory traces per channel
Measurement choices Option E5061A/E5062A-150/175: S
11
, S
21
Option E5061A/E5062A-250/275: S
11
, S
21
, S
12
, S
22
Measurement parameter conversion Available to convert S-parameters into reflection impedance, transmission impedance,
reflection admittance, transmission admittance, and 1/S.
Data formats Log magnitude, linear magnitude, phase, expanded phase, positive phase,
group delay, SWR, real, imaginary, Smith chart, polar.
Data markers 10 independent markers per trace. Reference marker available
for delta marker operation. Smith chart format includes 5 marker formats:
linear magnitude/phase, log magnitude/phase, real/imaginary,
R + jX, and G + jB. Polar chart format includes 3 marker formats:
linear magnitude/phase, log magnitude/phase, and real/imaginary.
Marker functions
Marker search Max value, min value, multi-peak, multi-target, peak, peak left, peak right, target,
target left, target right, and width parameters with user-defined bandwidth values.
Marker-to functions Set start, stop, center to active marker stimulus value; set reference to active
marker response value; set electrical delay to group delay at active marker.
Search range User definable.
Tracking Performs marker search continuously or on demand.
Fault location functions (Option E5061A/E5062A-100)
Transformation to distance and time domain Selectable transformation type from bandpass, lowpass impulse, lowpass step.
Selectable window from maximum, normal and minimum.
Measured number of points per sweep User definable from 2 to 1601.
Sweep type Linear sweep, segment sweep, log sweep and power sweep.
Segment sweep Define independent sweep segments. Set number of points, test port power levels,
IF bandwidth, delay time, sweep time and sweep mode independently for each segment.
Sweep trigger Set to continuous, hold, or single, sweep with internal, external, manual,
or bus trigger.
Power Set source power from -5 dBm (-45 dBm for option E5061A/E5062A-1E1/250/275)
to 10 dBm. The power slope function compensates source power level error.