Atec Agilent-E5062A - Manual (Page 14)

14
Table 1-17 Rear panel information
Description Supplemental information
External trigger connector
Type BNC, female
Input level LOW threshold voltage: 0.5 V
HIGH threshold voltage: 2.1 V
Input level range: 0 to +5 V
Pulse width ≥ 20 µsec, typical
Polarity Negative (downward) only
External reference signal input connector
Type BNC, female
Input frequency 10 MHz ±10 ppm, typical
Input level 0 dBm ±3 dB, typical
Internal reference signal output connector
Type BNC, female
Output frequency 10 MHz ±10 ppm, typical
Signal type Sine wave, typical
Output level 0 dBm ±3 dB into 50 Ω, typical
Output impedance 50 Ω, nominal
VGA video output 15-pin mini D-Sub; female; drives VGA compatible monitors
GPIB 24-pin D-Sub (type D-24), female; compatible with IEEE-488
Parallel port 36-pin D-Sub (type 1284-C), female; provides connection to printers, or multiport
test set
USB port Universal serial bus jack, type A configuration (4 contacts inline, contact 1 on left);
female; provides connection to printer, ECal module, USB/GPIB interface
Contact 1 Vcc: 4.75 to 5.25 VDC, 500 mA, maximum
Contact 2 -Data
Contact 3 +Data
Contact 4 Ground
LAN 10/100 BaseT Ethernet, 8-pin configuration; auto selects between the two data rates
Handler I/O port 36-pin D-sub, female; provides connection to handler system
Line power 1
Frequency 47 Hz to 63 Hz
Voltage 90 to 132 VAC, or 198 to 264 VAC (automatically switched)
VA max 350 VA max.
1. A third-wire ground is required.