Atec Anritsu-MT8212E-MT8213E - Manual (Page 2)

2 of 32 PN: 11410-00485 Rev. M MT8212E and MT8213E TDS
Specifications Cell Master™ MT8212E and MT8213E
Cable and Antenna Analyzer
Measurements
Measurements VSWR
Return Loss
Cable Loss
Distance-to-Fault (DTF) Return Loss
Distance-to-Fault (DTF) VSWR
1-Port Phase
Smith Chart (50/75 Ω selectable)
Setup Parameters
Measurement Display Single/Dual Measurement Display with independent markers
Frequency Start/Stop, Signal Standard, Start Cal
DTF Start/Stop, DTF Aid, Units (m/ft), Cable Loss, Propagation Velocity, Cable, Windowing
Windowing Rectangular, Normal Side Lobe, Low Side Lobe, Minimum Side Lobe
Amplitude Top, Bottom Auto Scale, Full Scale
Sweep Run/Hold, Single/Continuous, RF Immunity (High/Low), Data Points, Averaging/Smoothing,
Output Power (High/Low), RF Pwr When Hold (On/Off)
Data Points 137, 275, 551, 1102, 2204
Markers Markers 1-6 (On/Off), Delta Makers 1-6 (On/Off), Marker to Peak/Valley, Peak/Valley Auto,
Marker Table (On/Off), All Markers Off
Traces Recall, Copy to Display Memory, No Trace Math, Trace ± Memory, Trace Overlay (On/Off)
Limit Line On/Off, Single Limit, Multi-segment Edit, Limit Alarm (On/Off), Pass Fail Message (On/Off), Pass/Fail
(Unbounded/Bounded), Warning Limit Offset, Clear Limit
Calibration Start Cal, Cal Type (Standard/FlexCal), Disp Valid Cal Temp Range
Save/Recall Setups, Measurements, Screen Shots (.jpg) (save only)
Frequency
Frequency Range 2 MHz to 4 GHz (MT8212E), 2 MHz to 6 GHz (MT8213E)
Frequency Accuracy ≤ ± 2.5 ppm @ 25 ºC
Frequency Resolution 1 kHz (RF immunity low), 100 kHz (RF immunity high)
Output Power
High 0 dBm, typical
Low –30 dBm, typical
Interference Immunity
On-Channel +17 dBm @ > 1.0 MHz from carrier frequency
On-Frequency 0 dBm within ± 10 kHz of the carrier frequency
Measurement Speed
Return Loss ≤ 1.00 ms/data point, RF immunity low, typical
Distance-to-Fault ≤ 1.25 ms/data point, RF immunity low, typical
Return Loss
Measurement Range 0 dB to 60 dB
Resolution 0.01 dB
VSWR
Measurement Range 1:1 to 65:1
Resolution 0.01
Cable Loss
Measurement Range 0 dB to 30 dB
Resolution 0.01 dB
Distance-to-Fault
Vertical Range Return Loss 0 dB to 60 dB
Vertical Range VSWR 1:1 to 65:1
Fault Resolution (meters) (1.5 x 10 8 x vp) / ΔF (vp = velocity propagation constant, ΔF is F2–F1 in Hz)
Horizontal Range (meters) 0 to (Data Points–1) x Fault Resolution, to a maximum of 1500 meters (4921 feet)
1-Port Phase
Measurement Range –180º to +180º
Resolution 0.01º
Smith Chart
Resolution 0.01 50/75 Ohm Selectable