Atec Anritsu-MT8212E-MT8213E User Manual
Page 18
PN: 11410-00485 Rev. M
MT8212E and MT8213E TDS
Specifications
Cell Master™ MT8212E and MT8213E
DVB-T/H (Options 0064, 0057, 0078)
For full specifications refer to the Digital Broadcast Analysis Options Technical Data Sheet 11410-00624
Setup Parameters
Channel Map
UHF (Australia), UHF (Europe), VHF (Europe), None
Channel
28 to 69 (Australia), 21 to 69 (Europe), 5 to 12 (Europe)
Frequency Offset
± 166.666 kHz, ± 333.333 kHz, ± 499.999 kHz, None
Frequency
30 MHz to 2.8 GHz when Channel Map is None
Bandwidth
5*, 6*, 7, 8 MHz
Pre-amp
On, Off
Reference Level
–25 dBm to +20 dBm/5 dB steps (Preamp Off), –50 dBm to –10 dBm/10 dB steps (Preamp On)
DVB-T/H Digital Video Measurements (Option 0064)
Channel Power Accuracy
± 2 dB, (RF input –84 dBm to –10 dBm)
Frequency Lock Range
± 90 kHz
Frequency Offset Accuracy
± (measurement frequency x reference frequency accuracy) ± 0.3 Hz
Residual MER
≥ 42 dB (Preamp Off, Reference Level: –20 dBm)
≥ 37 dB (Preamp On, Reference Level: –50 dBm)
Impulse Response Resolution
0.11 µs (Bandwidth: 8 MHz), 0.1 dB
Carrier MER Marker
Carrier Number, Offset Frequency and MER
Composite View
Simultaneous display of Constellation (Data and TPS), Impulse Response, Carrier MER and Frequency
Response
DVB-T/H BER Measurements (Option 0057) (Operating temperature range 0 ºC to 40 ºC)
Bit Count Setting
Range 1E+6 to 1E+12
Service Type
In Service: BER measurement of normal in-service data traffic
Simultaneous BER measurement Before Viterbi and Before RS error correction
Out of Service: BER measurement of a PRBS23 data sequence
BER measurement point can be selected Before Viterbi, Before RS or After RS
TPS Information
Length indicator, Mode, GI, Modulation, Hierarchy, Inner Interleave, Cell ID, Code Rate, Time Slicing,
MPE-FEC
ASI Output
BNC-J 75 Ω
DVB-T/H SFN Measurements (Option 0078)
Impulse Response Display Range
–896 µs to +896 µs (Bandwidth 8 MHz)
Resolution
0.11 µs (33 m) (Bandwidth 8 MHz)
Marker
Delay time, relative level (DU ratio), power and field strength or termination voltage
Inband Spectrum Range
± 3.804 MHz (Bandwidth 8 MHz)
*Not available for BER measurements
Measurements
DVB-T/H RF
(Option 0064)
DVB-T/H Signal Analysis
(Option 0064)
DVB-T/H BER Analysis
(Option 0057)
DVB-T/H SFN Analysis
(Option 0078)
Signal Power
Channel Power
Termination Voltage
Open Terminal Voltage
Field Strength
Spectrum Monitor
Channel Power
Zone Center Channel
Zone Center Frequency
Shoulder Attenuation
Channel Power
Zone Center Channel
Zone Center Frequency
Lower Shoulder Attenuation
Upper Shoulder Attenuation
Composite or Individual Views
Constellation
Impulse Response (w/zoom)
Carrier MER (w/zoom)
Freq Response (composite view
only)
Measured Data
Mode, GI
Modulation
Hierarchy
Freq Offset
Channel Power
MER (Total/Data/TPS)
TPS Warning Message
TPS Info
Interleave Type
Cell ID
Code Rate (HP/LP)
Time Slicing (HP/LP)
MPE-FEC (HP/LP)
BER
Before RS
Before Viterbi
PER (Packet)
Channel Power
MER (Quick)
Bit Rate
TPS Info
Length Indicator
Mode, GI
Modulation
Hierarchy
Interleave Type
Cell ID
Code Rate
Time Slicing
MPE-FEC
TPS Warning Message
ASI Out
Impulse Response (w/zoom)
Inband Spectrum
Measured Data
Channel Power
Delay
DU Ratio
Power
Field Strength