Alpha Technologies Cordex CXPS-D 48-2500_5000A - Manual (Page 32)

-5HY%
5.4 Installing the Inter-bay DC Bus Work and Cabling
The inter-bay DC bus work ships as a kit that is sized according to the number of rectifiers and current demand
of the load.
5.4.1 Remove rear covers/brackets
This procedure is written for the addition of an
adjacent bay to the right (from the rear) of the
existing bay. Adapt for your configuration.
1. Remove the Kydex rear covers of both
bays. (Save all screws for reinstallation of
covers.)
2. Remove the middle, cover-support
bracket (Figure 19) on the adjacent edges
of EACH bay to make room for the inter-
bay bus work.
0LGGOH
FRYHUVXSSRUW
EUDFNHW
)LJXUH ² 5HPRYDORIPLGGOHFRYHUVXSSRUWEUDFNHW
,WPD\EHQHFHVVDU\WRVOLJKWO\PRYHWKHED\VLQRUGHUWRSHUIRUPWKH¿QDODOLJQPHQW
IRUWKHFRQQHFWLRQSRLQWVLQWKHIROORZLQJSURFHGXUH,QDQHZLQVWDOODWLRQWKHIUDPH
DQFKRUVVKRXOGQRWKDYHEHHQVHWFRPSOHWHO\DVSHULQVWUXFWLRQVLQVHFWLRQ:KHQ
DGGLQJDQHZIUDPHWRDZRUNLQJV\VWHPLWPD\EHQHFHVVDU\WRORRVHQWKHÀRRUDQ
FKRUVLQWKHH[LVWLQJIUDPHWRSHUPLW¿QDODOLJQPHQW
127(