ABUS FU8007 Secvest 2WAY Base Kit Operating instructions - Manual (Page 48)

A1 - IV
3.2. FU8100 wireless remote control
User Menu
Æ System Config Æ Telecommands Æ 2 Way Instant Set Æ 2 Way Instant Set Y
2 Way Instant Set N
• “Y” (yes) is the default factory setting. The alarm centre is activated immediately when the FU8100 remote
control is pressed.
• When “N” (no) is selected, the actions set under the following positions are started when the remote control
is pressed:
Installer Menu
Æ Partitions Æ Partition 0x Æ Ext Mode Æ Timed Set
Final Door Set
Instant Set
Silent Set
The exit delay time is started for “Timed Set” or “Silent Set”, or the corresponding action is started for
“Final Door Set” or “Instant Set”.
• Pay attention to the reception time of the FU8100 remote control for feedback (approx. 10 seconds).
After this period has elapsed, the FU8100 remote control cannot display any more feedback.