ABUS FU8007 Secvest 2WAY Base Kit Operating instructions - Manual (Page 28)

28
System Rearmed The system has automatically reactivated itself
following an alarm.
U-- Z== Omit User -- has omitted zone ==.
Fire Z== Alarm Zone == has triggered a fire alarm.
Fire Z== Restore The fire alarm was confirmed.
Fire Reset The fire alarm was confirmed on the control
panel.
PA Z== Alarm Zone == has triggered a panic alarm.
PA Z== Restore The panic alarm of zone == was confirmed.
U-- System Reset User -- has reset the system.
Fire K== Alarm A fire alarm was triggered on the control panel.
PA K== Alarm A panic alarm was triggered on the control panel.
Medical K== Alarm A medical emergency was triggered on the
control panel.
Burg Z== Alarm Zone == has triggered an burglar alarm.
Set Fail Z== System activation has failed due to an error in
zone ==.
Burg Z== Restore The burglar alarm was confirmed.
Tamper Z== Zone == has triggered a tamper alarm.
Tamper Z== Restore The tamper alarm was confirmed.
K== Excess Keys The extra keys on the control panel were
activated.
Low Bat Z== The battery of the detector in zone == must be
replaced.
Low Bat Z== Rstr The battery in this zone is OK again.
RF Jamming Wireless jamming has occurred. The wireless
transmission was disturbed for at least 30
seconds within one minute.
RF Jamming Restore The jamming report was confirmed.
RF Sup Fail Z== Supervision has failed in zone ==. This zone has
not reported to the system for 2 hours.
RF Sup Rstr Z== The supervision failure message was confirmed.
PSTN Line Fault Error in the analogue telephone line.
PLGON Line Fault Transmission error via ISDN/GSM.
Entry Meaning
PSTN Line Restore Error in analogue telephone line was confirmed.
PLGON Line Restore Error in ISDN/GSM transmission was confirmed.
Comms Fail Error during transmission to security centre.
U-- Remote Download User -- has carried out remote maintenance.
U-- Download Fail User -- has an error in remote maintenance.
AC Fail Power failure.
AC Restore The power failure was confirmed.
Low Battery The system battery is not charged.
Low Batt Restore The battery error was confirmed.
Battery Load Fail The battery cannot be charged.
Tech Z== Alarm Zone == has triggered a technical alarm.
Tech Z== Restore The technical alarm was confirmed.
U-- Time/Date User -- has changed the date or time.
Soak Fail Z== Detector test in zone == has failed.
Test Call The system has made a test call.
Bad Checksum Misinterpretation in wireless transmission.
U-- Soc. Emergency A social care emergency has been triggered.
Social Inactive The social care function has been deactivated.
Key Box Open Z== The key box in zone == was opened.
Key Box Close Z== The key box in zone == was closed.
Key Sw Set Z== The key switch of zone == has activated the
system.
Key Sw Unset Z== The key switch of zone == has deactivated the
system.
U-- Ptn # Reset User -- has reset the partition.
RF Failure Error in wireless transmission.
RF Failure Restore Wireless transmission is OK again.
Social Emergency K== A social care emergency was triggered on the
control panel.
Fire Restore K== The fire alarm was confirmed.
PA Restore The panic alarm was confirmed.
U-- Ptn # PtSet User -- has activated a partition internally.
PA U-- Alarm User -- has triggered a panic alarm.
RF PA U-- Low Bat The panic detector battery must be replaced.
Entry Stray Z== Zone == has triggered an alarm during the entry
delay time.