ABUS FU8007 Secvest 2WAY Base Kit Operating instructions - Manual (Page 13)

13
11. Activating partitions
If the alarm system is set up so that two or more partitions can be monitored independently of each other, these partitions can now be individually activated or
deactivated. A user can now activate/deactivate one or more partitions, depending on the user authorisation. If the entire alarm system is activated, each partition is
also activated. If the user is authorised to activate one partition only, then this partition can be activated by entering the user code. If the user is authorised to
activate two or more partitions, then they must now select the partition to be activated. Partitions can also be activated/deactivated using the remote control or the
arming station. The remote control has the same authorisation as its assigned user.
11.1. On the system
Enter your user code or hold your chip key over
the system reader. If you are authorised to
activate more than one partition, the following
graphic display is shown:
Select “Partitions”.
Select the partition to be activated.
Change the settings for this partition.
The displayed codes next to the partition have
the following meanings:
Display Meaning
U This partition remains deactivated.
U>P This partition is activated internally.
U>S This partition is activated.
S>U This partition is deactivated.
P>U This partition is deactivated
internally.
S This partition remains activated.
P This partition remains activated
internally.
To activate one or more partitions, select U>S
next to the corresponding partition.
Confirm your entry by pressing Done.
The system then carries out the entered actions
(activation/deactivation).
11.2. Using the wireless remote
control
Using the FU5155 / FU5150 remote control unit,
partitions can be activated in two ways:
a) The remote control activates all partitions
within the user’s authorisation.
b) The keys of the remote control unit are
programmed in the user menu to activate
partitions individually.
Example of key settings:
See also “System Config”.
Complete activation (partitions 1 and 3)
Activate
partition
Activate
partition 3
Complete deactivation
When activation is confirmed, the system starts the delay time for the corresponding partition. At the same time,
the system emits an acoustic message. This is as follows:
“Partition
activated”
If the user activates all partitions for which they have authorisation, the message is as follows:
“Alarm system activated”