ABUS FU8007 Secvest 2WAY Base Kit Operating instructions - Manual (Page 41)

41
19.1. Errors, meanings, causes and suggested solutions
Displayed error Meaning Possible causes Suggested solutions
AC Fail The 230 V AC system
power supply is missing. • The main fuse of the PSU on the wireless
alarm system is not fitted correctly or is
defective.
• The connecting cable between the system
and the base plate is not inserted correctly.
• The main power supply to the PSU of the
base plate has failed or the power cable
was not fitted correctly.
• PSU in base plate is defective.
• Replace the main fuse with one of the same
rating.
• Check that the fuse is correctly fitted.
• Check the correct installation of the system to
the base plate and plug the connecting cable
into the correct base plate socket.
• Check that your mains power fuse is active for
the system. Is there a 230 V power supply?
• Check the correct connection between the mains
power line and the PSU clamp.
• Contact your installer.
WAM__PSU Fail 230 V AC power supply is
missing in the accessory
module. • The mains power cable to the 12 V power
supply is not connected correctly.
• The PSU is not supplied with power.
• The PSU that supplies power to the
accessory module is defective.
• Check the correct installation of the 12 V DC
connecting cable.
• Check that the PSU is inserted and the red LED
on the PSU is lit.
• Contact your installer.
Batt Low No battery power supply
to the system. • The inserted batteries are not fully charged. • This error should disappear when the batteries
are fully charged.
• After a maximum of 4 hours, the batteries are
charged and this display disappears.
WAM Low Batt No battery power supply
to the accessory module. • The lead-acid battery has not yet been
charged.
• No lead-acid battery was connected.
• This error should disappear when the battery is
fully charged.
• Check the correct installation of the 6 V, 1.2 Ah
lead-acid battery in the accessory module.