ABUS FU8007 Secvest 2WAY Base Kit Operating instructions - Manual (Page 31)

31
Outputs
A list of all outputs installed on the system is shown on the display. Select the
output to be tested. Press Done to end the test.
IMPORTANT: Ensure that nobody attempts to activate the WAM using a
remote control or social care transmitter during the test. When the test
is ended, check whether the output has the required status.
Telecommands
Press any key on the remote control. The remote control user, the key
pressed according to the wireless centre programming and the signal strength
are all shown on the display. Press all keys on the remote control one after
another.
Pendants
Press the button on the pendant. The identity of the user assigned to the
pendant is displayed.
PA Detector
Press the button on the panic transmitter. The identity of the user assigned to
the panic transmitter is displayed.
Tag
Hold the chip key (tag) at the top-left corner on the front of the alarm centre.
The identity of the user assigned to the chip key is shown on the display.
18.9. System configuration
This menu is used to change individual system settings, such as date and
time, outputs and remote controls.
Select the System Config menu item.
Select the item where the settings should be changed. Exit this menu item by
pressing Back.
The items have the following meanings: