ABUS FU8007 Secvest 2WAY Base Kit Operating instructions - Manual (Page 21)

21
18.4. Omitting zones
If necessary, you can remove zones from surveillance (e.g. if a detector is
defective or a zone cannot be closed).
Select the Omit Zones menu item.
The system displays all trained zones. Select the zone where the settings
should be changed.
The settings are as follows: M = Monitored / O = Omitted (not monitored)
The setting can be changed here.
When the settings have been made, finish data entry by pressing Done.
These zones are not monitored when the wireless alarm system is activated.
The next time the alarm system is deactivated, these zones are
automatically included again and have to be removed again from
monitoring manually.
18.5. Installing users
As an administrator, you can use your code (master code) to install further
users for the wireless alarm system. Up to 50 users can be installed on the
system. This menu item is also used for training the remote control, the
emergency and panic detectors and the chip key.
Select the User
menu item.
You can now edit user settings, add a new user or delete an existing user
together with all settings.
To edit the user settings, first select the Edit User menu item.