Extron Electronics System 5 IP Series Setup Guide - Manual (Page 26)

System 5 IP Switchers • Software Setup
System 5 IP Software Setup, cont’d
3-22 System 5 IP Switchers • Software Setup 3-23
6 . Set the lamp hour limit by doing the following:
a
. Choose Lamp Usage Time (hours): Value under the
Available Options window.
b . Enter a value (800, for example) in the Lamp Usage
Time (hours) box.
c . Click Apply Condition.
d . Click Next.
7 . Click Next again to add an e-mail notification.
Display lamp hour e-mail notification
8 . Click on the appropriate e-mail message and contacts, then
click Apply Email/Contacts.
9 . Click Done. The dialog box closes.
Step 10: Create a Dsplay Dsconnecton
E-mal
To set a display disconnected e-mail alert, do the following:
1
. Click the Monitor tab in the Global Configurator window.
2 . Click the Add Monitor button below the Monitored
Conditions window. The Monitored Conditions Wizard
window appears.
3 . Enter a name (Disconnected) in the Enter Monitored
Condition Name field area. The label now appears in the
left pane.
4 . Click Next to specify a condition.
5 . Select the desired equipment (for our purposes, choose the
Epson PowerLite 7700p ) from the Subject Port window
and Connection Status is Disconnected from Available
Options .
6 . Click Apply Condition, then click Next.
7 . Click Next again to add an e-mail notification.
8 . Highlight the appropriate e-mail message (Disconnect
Notification ) and contacts (e-mail recipient(s)), and click
Apply Email/Contacts .
9 . Click Done. The dialog box closes.
Step 11: Buld and Upload a Configuraton
The Global Configurator project file contains all the
configuration data (port assignments, product/device locations,
scheduling data, etc.) you have created in Global Configurator.
This is the data used to build the project's GlobalViewer Web
pages for the System 5 IP.
Buldng a configuraton
To build a configuration, do the following:
1
. Click the GlobalViewer tab at the left window to open
GlobalViewer Designer.
2 . Confirm that all configured products have been given a
location. If not, drag each product to the desired location
or create new ones.
3. Save your project file. If a project file has not been
saved, GC prompts you to do so before building the
configuration.
4 . From the Build menu, choose Build All Configurations or
Build Changed Configurations
.
The Build menu
An activity bar appears, indicating that the build is
progressing. The Upload Manager dialog box appears
when the build is complete.