beautypg.com

Control software for windows, Advanced instructions, Installing the software – Extron Electronics SGS 408 User Guide User Manual

Page 49

background image

4-7

SGS 408 Switcher • Serial Communication

Query Software Version

Q/q

Ver x.xx

Example response: Ver 1.23

Request Part Number

N/n

Nxx-xxx-xx

N60-341-01

Request Information
Program or preview

X2

I/

X2

i

C

X1

•Frz

X15

•Mut

X15

•Hrt

X16

•Vrt

X16

General

I/i

Exe

X15

•Loc

X15

•Dvi

X15

Examples:

1I

C2•Frz 0•Mut 0•Hrt 112.20•Vrt 75.02
Program information: Input channel 2, freeze mode is off, mute
mode is off, horizontal refresh rate is 112.20 kHz, vertical refresh
rate is 75.02 Hz

I

Exe 0•Loc 1•Dvi 1
General information: Executive mode is off, program lockout is on,
DVI connector is installed

Advanced Instructions

The Advanced Instructions use hex commands that are more complex than the
Simple Instruction Set.

COMMAND

HEX

RESPONSE

Read/Write Entire Memory
Read (upload)

90 91

8 kbytes of data + 1 byte checksum

Write (download)

90 92 + 8 kbytes of data + 1 byte checksum

Dnl

Read/Write Memory Block
Read to current memory block

X2

90 93

16 bytes of data + 1 byte checksum

Write to a user preset

X3

90 94 + 16 bytes of data + 1 byte checksum

Dnl

Control Software for Windows

The SGS 408 Control Program, which is used by the SGS 408, is compatible with
Windows 95/98/2000, and NT. It provides remote control of various functions
including input selection, picture controls, effects, transitions, and output rates.

If an ECP 1000 event control panel is attached to the SGS 408, refer to the
ECP 1000 User’s Manual for information on running the SGS 408 Control
Program.

Installing the software

The program is contained on a set of 3.5-inch diskettes. To install the program
from the floppy disk to the hard drive, run SETUP.EXE from the floppy disk and
follow the instructions that appear on the screen. The program occupies
approximately 3 MB (megabytes) of hard-drive space.

By default, the Windows installation creates a C:\SGS408 directory, and it will
place two icons (SGS 408 Control Pgm and SGS 408 Help) into a group or folder
named “Extron Electronics”.

COMMAND

RESPONSE

DESCRIPTION