Extron Electronics SGS 408 User Guide - Manual (Page 3)

QS-1 SGS 408 • Quick Start
Quick Start — SGS 408
Installation
Step 1
Install the four rubber feet on the bottom of the
SGS 408 switcher, or mount the switcher in a
rack (1).
Step 2
Turn off power to the input and output
devices, and remove the power cords from
them.
Step 3
Attach the input and output devices to the
switcher (3A).
Input options (3B) are:
• Component Y, R-Y, B-Y (connect Y, R-Y,
and B-Y)
• RGsB (connected to R, G, and B)
• RGBS (connected to R, G, B, and H/HV)
• RGBHV (connected to R, G, B, H/HV, and
V).
Output options are RGBS, RGBHV, and DVI-D
(if the DVI option is installed).
The program output displays the image seen
by the audience. The preview output displays
the image that will be switched next.
Step 4
If desired, attach an RCP 1000 remote control
panel to the XLR connector on the rear of the
SGS 408.
Step 5
If desired, attach an ECP 1000 event control
panel to the RS-232 connector on the rear of
the SGS 408.
Step 6
Plug the switcher, input devices, and output
devices into a grounded AC source, and turn
on the input and output devices.
Step 7
Use the LCD screens to configure the scaler
(see the next page).
PR OG RA M
FR EE ZE BL AC K 1 2
3
4 5
6
7 8
CU T TA KE PR OG RA M
PR EV IEW
OU TP UT RA TE
EF FE CT
TR AN SIT IO N
SG S 4 08
SE AM LE SS G RA PH IC SW ITC HE R INP UT
1 2
3
4
TR AN SIT IO NS
EF FE CT S
RC P C OM MU NIC AT IO N
PR EV IEW
FR EE ZE BL AC K 1
2
3 4
5
6 7
8
Tx Rx
1
Projector
SGS 408 Program
Monitor
Up to 8 Inputs
Preview
Monitor
PC Computer
PR OG RA M
FR EE ZE BL AC K 1 2 3 4 5 6 7 8 CU T TA KE PR OG RA M PR EV IEW OU TP UT RA TE
EF FE CT TR AN SIT IO N
SGS 408
SE AM LE SS G RA PH IC SW ITC HE R INP UT
1 2
3 4
TR AN SIT IO NS
EF FE CT S
RC P C OM MU NIC AT IO N
PR EV IEW
FR EE ZE BL AC K 1 2 3 4 5 6 7 8
Tx Rx
RGB 109 xi
DVD Player
3A
3B
RGsB
(input only)
RGBS RGBHV
15-pin HD
(output only)
DVI-D
(output only)
Component
R/R-Y
G/Y
B/B-Y
R/R-Y R/R-Y R/R-Y
G/Y G/Y G/Y
B/B-Y B/B-Y B/B-Y