Extron Electronics MVP 104GX User Guide - Manual (Page 46)

MVP 104GX Programmer’s Guide
Programmer’s Guide, cont’d
5-8
T2•Aud+02•Col100•Tin22•Con95•Brt20•Frz0•Blk0•Det1
•Kro1•[FEW WORDS]
The following response example refers to input 2.
Video type detected (T) = 2 (PAL)
Audio gain (Aud) = +02dB
Picture color (Col) = 100
Picture tint (Tin) = 22
Picture contrast (Con) = 95
Picture brightness (Brt) = 20
Freeze window (Frz) = 0 (off, i.e. image not frozen)
Window blanking (Blk) = 0 (blanking off, i.e. window is visible)
Enable VCR mode (Det) = 1 (on)
Enable Chroma (Kro) = 1 (on)
Window text ([]) = FEW WORDS (user-defined text)
MVP 104GX error responses
When the MVP 104GX receives an SIS command and determines that it is
valid, it performs the command and sends a response to the host device. If
the MVP 104GX is unable to perform the command because the command is
invalid or contains invalid parameters, the MVP 104GX returns an error
response to the host. The error response codes are:
E01 — Invalid input number
E09 — Invalid function number (too large)
E10 — Invalid command
E11 — Invalid preset
E13 — Invalid value (out of range)
MVP 104GX-generated unsolicited responses
Whenever there is a front panel operation (only), the MVP 104GX responds
by sending an unsolicited response (Reconfig##) to the Host. Use the 2 digit
code ## to locate the event below.
Reconfig00 = More than one window configuration changed
Reconfig01 = Window 1’s configuration changed
Reconfig02 = Window 2’s configuration changed
Reconfig03 = Window 3’s configuration changed
Reconfig04 = Window 4’s configuration changed
Reconfig20 = Audio selection changed