Extron Electronics MVP 104GX User Guide - Manual (Page 12)

MVP 104GX Installation
Installation, cont’d
13 Genlock input — Connect an external black burst signal for genlocking the
video signal in broadcast or other sync-critical applications.
14 Genlock output — Connect any downstream equipment that requires
genlocking for broadcast or other sync-critical applications.
Connecting the MVP 104GX
The MVP 104GX can be connected to as many as four input devices simultaneously
and output to as many as three devices simultaneously. Follow the steps below
and see the installation example in figure 2-3.
Figure 2-3 — MVP 104GX installation example
1 If the MVP 104GX is to be rack mounted, see the earlier Rack Mounting
Procedure.
2 Turn off power to the MVP 104GX and all other devices that will be
connected.
3 Using Inputs 1, 2, 3, and 4, attach up to four composite/S-video input devices
to the MVP 104GX. Inputs 1 and 2 can be either composite video or
S-video, inputs 3 and 4 are composite video only. The buffered loopout
connectors for all inputs can be used to output the identical signal to other
devices.
Any inputs must be either all NTSC or all PAL, they cannot be both.
2-4
50/60 Hz
100-240 V 0.3A
S-VIDEO
R-Y/B-Y/Y
RGB
R/R-Y
H V S
G/Y B/B-Y
RS-232 OUT
IN GENLOCK
S-VIDEO P A L OUT 75 OHM
VIDEO
MAC
VGA
I N
P
U
T
S
O
U
T
P
U
T
S
REMOTE
RS-232/RS-422
100-240V 50/60 Hz 0.5A
INPUT 1
IN
OUT
INPUT 2
IN
OUT
OUTPUT
A
B C
1 L R
INPUTS OUTPUT
INPUT 3
IN
OUT
INPUT 4
IN
OUT
2 L R 3 L R 4 L R 1 L R
VSC 150
INPUTS
OUTPUTS
Rear
Document
Camera
RS-232
Control
Video
Camera
VCR
VCR Plasma Display Videoconferencing
System
PC Computer
GENLOCK
IN OUT