Extron Electronics MVP 104GX User Guide - Manual (Page 27)

MVP 104GX Operation 3-9
Using the Menu System
The MVP 104GX menu system is accessed through the Menu and Next buttons
while viewing the LCD panel display. See the previous Menu Flowchart section as a
helpful guide while navigating the menu system. Use the chart below to reference
the various flowchart arrows.
Figure 3-5 — MVP 104GX flowchart arrow designations
Default Cycle menu
After the initial power on of the MVP 104GX, the LCD displays a default cycle of
two informational submenus, with each submenu appearing in 2-second intervals.
Each submenu is for information only and displays the product name and the
product type. While in this cycle, any user-
enabled Input selection button LEDs light green.
Product Name submenu
This submenu identifies the product name
as the MVP 104GX. Press the Menu button
to exit the Default Cycle menu and advance
to the Picture Controls menu.
To adjust any active window’s sizing or
positioning, press the appropriate Active
window selection
button.
Product Type submenu
This submenu describes the product type
as a multi video processor. Press the Menu
button to exit the Default Cycle menu and
advance to the Picture Controls menu.
To adjust any active window’s sizing or positioning, press the appropriate
Active
window selection button.
Position/Size Window menu
While the MVP 104GX is in the Default Cycle menu,
pressing the Active window selection button selects
the Position/Size Window menu for the chosen
window (#1, 2, 3, 4, or none). The active window can
be sized and positioned either horizontally or
vertically by viewing the active window and adjusting
the appropriate knob, as indicated by the following
illustrations.
2 -second default cycle press Menu button press Next button
press Freeze and Next
buttons simultaneously press the Active window
selection button 16-second time-out
select blanking
and press Next button
Power
On
Extron
MVP 104GX
Multi Video
Processor
Position/Size
Window #1 – 4