Extron Electronics MSX1616HR - Manual (Page 29)

27

2002 - INLINE, INC. MSX1616 OPERATION MANUAL - v1.0 5/8/02
Set-Up Commands
These commands are for configuring the switcher and only need to be sent once. If using a third
party control system, most commands in this section should be placed in the start-up section of
the program.
COMMAND DESCRIPTION
[ARC] Request for model and version information.
[CPx@] Re-sets a specific port to default of 9600, 8, N and 1.
•
Where
o x = 1 - 3 for specific port
[CPx?] Query a specific port for current settings.
•
Where
o x = 1 - 3 for specific port
[CPxbpsfd] Configures a specific port for baud rate, parity, stop bits, flow control
and duplex.
•
Where
o x = 1 - 3 for specific port
o b = 0 for 1200, 1 for 2400, 2 for 4800, 3 for 9600, 4 for
19200, 5 for 38400
o p = 0 for no parity, 1 for odd parity, 2 for even parity
o s = 0 for 1 stop bit, 1 for 2 stop bits
o f = 0 to disable flow control, 1 to enable flow control
o d = 0 for full duplex and 1 for half duplex
[DFLTx] Performs factory reset. The partial reset will default I/O configurations,
volume levels and serial set-up, but does not reset projector codes
and/or presets. A full reset will reset all parameters including projector
codes and presets, and will take up to 2 minutes.
•
Where
o x = 0 for partial reset, 1 for full reset
[FPx] Enable/disable front panel control and request current status.
•
Where
o x = 0 to disable, 1 to enable
o x = ? to request current state
o x = (left blank) to toggle current state
[LBLIiiabcde…] Allows for custom labeling to be displayed on LCD for all inputs, up to
20 characters
•
Where
o ii = 01 – 16 for input
o abcde = custom label up to 20 characters, ? to query
[LBLOooabcde…] Allows for custom labeling to be displayed on LCD for all outputs, up
to 20 characters.
•
Where
o oo = 01 - 16 for output
o abcde = custom label up to 20 characters, ? to query
[RESx] Enable/disable serial responses from switcher.
•
Where
o x = 0 to disable, 1 to enable, ? to query