Opening the embedded web pages – Extron Electronics GSS 100 User Guide User Manual
Page 38
Opening the Embedded Web Pages
Access the GSS 100 using HTML pages as follows:
1.
Start the web browser program.
2.
Click in the
Address
field of the browser.
3.
Enter the IP address of the GSS in the
Address
field of the browser.
NOTE: If the local system administrators have not changed the value, the factory-
specified default, 192.168.254.254, is the correct value for this field.
4.
If you want the browser to display a page other than the default page (such as a custom
page that you have uploaded), enter a slash (/) and the name of the file to open.
NOTES:
•
The
Address
field of the browser should display the address in the
following format:
xxx.xxx.xxx.xxx
/{
optional_file_name.html
}.
•
The following characters are invalid in file names:
{space} + ~ , @ = ‘ [ ] { } < > ’ “ “ ; : | \ and ?.
5.
Press the keyboard
If the GSS 100 is not password protected, it checks and downloads the HTML pages
(proceed to step 7).
If the GSS 100 is password protected, the GSS 100 downloads the Enter Network
Password page (see figure 18).
Figure 18.
Enter Network Password page
NOTE: A User name entry is not required.
6.
Click in the
Password
field and type in the appropriate administrator or user password.
Click the
OK
button.
7.
The GSS 100 checks several possibilities, in the following order, and then responds
accordingly:
z
z
Does the address include a specific file name, such as
10.13.156.10/
file_name
.html? If so, the GSS 100 downloads that HTML page.
z
z
Is there a file in the memory of the GSS 100 that is named “index.html?”
If so, the GSS 100 downloads “index.html” as the default startup page.
z
z
If neither of the above conditions is true, the GSS 100 downloads the factory-
installed default startup page, “nortxe_index.html” (see figure 19), also known as
the System Status page.
GSS 100 Graphic Still Store • HTML Control and IPL File Manager
32