Extron Electronics GSS 100 User Guide - Manual (Page 26)

Output configuration
NOTE: The output configuration settings apply only to the the output of still images
stored in the GSS; the RGB pass-through video is output exactly as it is input.
RteX%*X^]
The GSS 100 initiates the
Rte message when a front panel change in the output resolution
takes place.
SynX&]
The GSS 100 initiates the
Syn message when a front panel change in the output sync format
takes place.
PolX*]
The GSS 100 initiates the
Pol message when a front panel change in the output sync
polarity takes place.
DlyX#]
The GSS 100 initiates the
Dly message when a front panel change in the RGB delay interval
takes place.
Auto-switch and slide show control
PasX@]
The GSS 100 initiates the
Pas message when a front panel change in the pass-through
configuration takes place.
AutX$]
The GSS 100 initiates the
Aut message when a front panel change in the auto-switch and
slide show on and off status takes place.
SliX#]
The GSS 100 initiates the
Sli message when a front panel change in the slide display
duration takes place.
Front panel locks
ExeX@]
The GSS 100 initiates the
Exe message when a front panel change in the front panel lock on
or off status takes place.
Host-to-GSS Instructions
SIS commands consist of one or more characters per field. No special characters are required
to begin or end a command character sequence. When a command is valid, the unit
executes the command and sends a response to the host device. All responses from the unit
to the host end with a carriage return and a line feed (CR/LF = ]), which signals the end of
the response character string. A string is one or more characters.
GSS 100 Graphic Still Store • Programming Guide 20