Command and response table for sis commands – Extron Electronics GSS 100 User Guide User Manual
Page 28
Command
ASCII Command
(Host to Unit)
Response
(Unit to Host)
Additional description
Image recall
Recall an image to buffer
EX!
RF
}
Cim
•
X!]
Select image
X!
to display.
NOTE: It takes several seconds between the issuance of the recall command (
EX!
RF
}
) and the receipt of the Cim response.
Show the image that is
currently displayed
E
RF
}
X!]
The buffer is loaded with image
X!
.
Take
%
Tke
]
Swap the displayed and buffered images using the
selected effect (cut or dissolve).
Switch effect
Set the effect to cut
9*0#
Eff0
]
Set the effect for switching images to cut (immediate).
Set the effect to dissolve
9*1#
Eff1
]
Set the effect for switching images to dissolve.
Read the effect
9#
X@]
Set the dissolve duration
10*
X#
#
Dur
X#]
Set the duration of the dissolve effect to
X#
.
Read the dissolve duration
10#
X#]
The dissolve duration is
X#
.
Source selection
Display pass-through
1!
Chn1
]
Display the pass-through input.
Display last image
0!
Chn0
]
Display the previously selected stored image.
View pass-through status
!
X@]
Pass-through mode is
X@
.
Slide show interval
Set slide show interval
2*
X#
#
Sli
X#]
Set the display time for each image to
X#
seconds.
Read slide show interval
2#
X#]
The display time for each image is
X#
seconds.
Pass-through configuration
Enable pass-through
1*1#
Pas1
]
Include the pass-through input in the slide show.
Disable pass-through
1*0#
Pas0
]
Do not include the pass-through input in the slide show.
Read the pass-through status
1#
X@]
Show the status of the pass-through.
Auto-switch and slide show mode
Set auto-switch and slide
show mode
4*
X$
#
Aut
X$]
Set auto-switch and slide show mode.
X$
definitions:
0 = Off — Auto-switch on loss of pass-through sync
and slide show are disabled.
1 = Off/show — Auto-switch on loss of pass-through
is disabled. Slide show is running.
2 = On/still — On loss of sync on the pass-through
input, auto-switch to display the last-
displayed image until pass-through
sync is restored.
3 = On/show — On loss of sync on the pass-through
input, auto-switch to run the slide
show until sync on the pass-through
input is restored.
Show auto-switch and slide
show mode
4#
X$]
Command and Response Table for SIS Commands
NOTE:
X!
= Image file name
Image name with file extension (*.bmp or *.jpg)
X@
= Cut / dissolve status:
0 = cut
1 = dissolve
Pass-through status:
0 = pass-thu
1 = no pass-thru
X#
= Time (duration)
00 – 50 (0.0 to 5.0 seconds) for dissolve duration
000 – 300 seconds for slide show interval
X$
= Auto-switch / slide show
0 = off
2 = on / still
1 = off / show
3 = on / show
GSS 100 Graphic Still Store • Programming Guide
22