Extron Electronics GSS 100 User Guide - Manual (Page 20)

Advanced menu
Figure 14 is a flowchart that shows an overview of the Advanced menu and the available
settings.
Menu 10 sec. 10 sec.
Power
on
Menu
Default
Cycle
Next
Menu
Menu
Menu
Menu
Menu
10
sec.
10
sec.
Advanced
Menu
Exit
Menu
10
sec.
10
sec.
10
sec.
Auto Sw
Off
Next Next
3 sec.
{scroll}
Name
GSS-100-
Auto Switch
• Off • Off/show
• On/still • On/show
Switch
Effect
Name (Display Only)
(Changeable under RS-232/Ethernet control;
scrolls to the left if greater than 8 characters.)
Next
Next Next
Next Int Temp
113F 45C
MAC Address
(Display Only)
Temperature
(Display Only)
Slide
Show
Output
Config
Baud Rate
• 2400 • 19200
• 4800 • 38400
• 9600 • 115200
Press Take to
enable changing
the value.
Rotate Adjust/
Select to change
the value.
Menu
Menu Menu
Menu Menu
I192.168
P254.254
RS-232
9600
Name
nn - nn - nn
nn : nn : nn
nn : nn : nn
TAKE Press Take to enable
changing the value
and select an octet.
Rotate Adjust/Select
to change the value in
the selected (blinking)
octet. TAKE
Figure 14. Advanced Submenu Flowchart
Auto Switch (and slide show) submenu
The GSS can be set to an auto-switch mode that monitors the sync signal on the RGB pass-
through input and automatically switches to the last-displayed stored image or slide show
for output when sync is lost. This submenu also allows you to turn the auto-switching and
slide show on and off.
Rotate the Adjust/Select mode while in the Auto-Switch submenu to select:
z z
Off (auto-switch mode off and slide show off) — Deactivates the automatic sync
detection and the slide show.
z z Off/show (auto-switch off and slide show on) — Leaves the automatic sync
detection off and manually initiates the slide show. If the pass-through input was being
displayed when this selection is made, the GSS displays the first image alphabetically by
file name.
z z
On/still (auto-switch on and slide show off) — Activates the automatic sync
detection and auto-switches to the still image. If sync is lost, the GSS switches to the last
displayed image that was output and outputs that image until sync is restored or you
select another image to display.
z z
On/show (auto-Switch on and slide show on) — Activates the automatic sync
detection and auto-switches to the slide show. If sync is lost, the GSS switches to the
last-displayed image and begins to cycle through the available images.
The default setting is Off.
GSS 100 Graphic Still Store • Operation 14