Extron Electronics GSS 100 User Guide - Manual (Page 12)

Reset Button
f
Reset button — The Reset button initiates three levels of reset to the GSS. Press and
hold the button while the GSS is running or while you power up the GSS for different
reset levels.
z z
Events (mode 3) reset — Hold the Reset button for approximately 3 seconds (the
Reset LED blinks once), then release it and push it again for a moment to toggle
events monitoring on and off.
z z
IP settings (mode 4) reset — Hold the Reset button for approximately 6 seconds
(the Reset LED blinks twice), then release it and push it again for a moment to reset
the IP functions of the GSS.
z z
Absolute (mode 5) reset — Hold the Reset button for approximately 9 seconds
(the Reset LED blinks three times), then release it and push it again for a moment to
restore the GSS to the default factory conditions.
NOTE: The absolute (mode 5) reset clears all image files, IP settings, and user
settings and resets the graphic still store to the factory default.
GSS 100 Graphic Still Store • Installation 6