Xylem Fixed speed booster sets programming manual/Electronic control board SM30 User Manual

Page 37

↓DOWN buttons to change the value.
If a parameter is a number of several figures, these are changed separately, press OK/MENU to move on
to the next figure.
Once the desired value has been obtained, press OK/MENU to confirm the value or press P3 (ESC) to
cancel.

To leave a menu or a submenu, press P3 (ESC) or repeatedly press the

↑UP or ↓DOWN key until it gives

the message EXIT, select YES and confirm with OK/MENU .

Default Values

Default Values
The default values are those set in the factory and they may be reset on the DEFAULT menu.

6 PROGRAMMING

The adjustments may influence correct operation of the set.

6.1 Service menu

6.1 Service menu
Modifications to the service menu must be made by qualified personnel.

When switching on the board, press the OK/MENU and

↑UP buttons until this message appears on the

display:

PASSWORD SERVICE

[00066]

Set the password 00066 with the

↑UP and ↓DOWN buttons and confirm with OK/MENU to enter the

service menu.
If the password is wrong, the menu is proposed in read-only mode and this window appears:

WRONG PASSWORD

READ ONLY

Display

Comment

Field

Default

LANGUAGE

Language setting.

Some languages may not be active, in this
case the messages are automatically displayed
in Italian.

ITALIANO,
ENGLISH,
FRANÇAIS,
DEUTSCH,
PORTUGUÊS,
ESPANÕL

ITALIANO

AUTO ENABLE

Modification of some parameters enabled in
AUTOMATIC mode.

YES
NO

CAUTION