2 configuring an expansion card, Configuring an expansion card -14, Standard interrupt assignments – Asus RS320Q-E7/RS12 User Manual
Page 34
Chapter 2: Hardware setup
2-14
2.5.2
Configuring an expansion card
After installing the expansion card, configure it by adjusting the software settings.
1.
Turn on the system and change the necessary BIOS settings, if any. See Chapter 5 for
information on BIOS setup.
2.
Assign an IRQ to the card. Refer to the following tables.
3.
Install the software drivers for the expansion card.
* These IRQs are usually available for ISA or PCI devices.
Standard Interrupt assignments
IRQ
Priority Standard function
0
1
System Timer
1
2
Keyboard Controller
2
-
Programmable Interrupt
4*
12
Communications Port (COM1)
5*
13
--
6
14
Floppy Disk Controller
7*
15
--
8
3
System CMOS/Real Time Clock
9*
4
ACPI Mode when used
10*
5
IRQ Holder for PCI Steering
11*
6
IRQ Holder for PCI Steering
12*
7
PS/2 Compatible Mouse Port
13
8
Numeric Data Processor
14*
9
Primary IDE Channel
15*
10
Secondary IDE Channel
5.
Press the riser card bracket until the
golden connectors completely fit the
slot and the bracket aligns with the rear
panel.
6.
Connect the cables to the card, if
applicable.