Asus ESC2000 G2 - Manual (Page 154)

5-24 Chapter 5: RAID configuration
5.3 Intel ® Rapid Storage Technology
enterprise SCU/SATA Option ROM Utility
The Intel ® Rapid Storage Technology enterprise SCU / SATA Option ROM utility allows you
to create RAID 0, RAID 1, RAID 10 (RAID 1+0), and RAID 5 set(s) from Serial ATA hard disk
drives that are connected to the Serial ATA connectors supported by the Southbridge.
You can create RAID mode by use of onboard AHCI SATA ports.
To use onboard SATA ports:
1. Install all the Serial ATA hard disk drives.
2. Turn on the system. During POST, press, to enter BIOS. Go to Advanced
Menu > PCH SATA Configuration > SATA Mode, then press .
3. Set SATA Mode to RAID Mode and save, then reboot system.
4. During POST, press to display the utility main menu.
To use SCU SATA ports:
1.
Install all the SATA hard disk drives.
2. Turning on the system. During POST, press to enter BIOS. Go to Advanced
Menu > PCH SCU SATA Configuration, then press .
3. Confirm all the SATA hard disk drives you installed are correctly displayed, then reboot
system.
4. During POST, press to display the utility main menu.
To enter the Intel ® Rapid Storage Technology enterprise SATA/SCU Option ROM utility:
1. Install all the Serial ATA hard disk drives.
2. Turn on the system.
3. During POST, press to display the utility main menu.
Intel(R) Rapid Storage Technology - Option ROM - v3.0.0.1184
Copyright(C) 2003-11 Intel Corporation. All Rights Reserved.
[ MAIN MENU ]
1. Create RAID Volume 3. Reset Disks to Non-RAID
2. Delete RAID Volume 4. Exit
[ DISK/VOLUME INFORMATION ]
RAID Volumes:
None defined.
Physical Disks:
ID Drive Model Serial # Size Type/Status(Vol ID)
0 ST3300656SS HWAS0000991753TR 279.3GB Non-RAID Disk
1 ST3300656SS 37VN00009846RAJ1 279.3GB Non-RAID Disk
2 ST3300656SS 397600009846UEDY 279.3GB Non-RAID Disk
3 ST3300656SS GWC50000991756G6 279.3GB Non-RAID Disk
[↑↓]-Select [ESC]-Exit [ENTER]-Select Menu