Asus ESC2000 G2 - Manual (Page 103)

ASUS ESC2000 G2 4-27
Aggressive Link Power Management [Enabled]
Configuration options: [Enabled] [Disabled]
Port 1-6 Staggered Spin-up [Disabled]
Configuration options: [Enabled] [Disabled]
IDE Mode
Allows you to to enable or disable the SATA controllers.
Serial-ATA Controller 0 [Enhanced]
This item appears only when you set the SATA Mode item to [IDE Mode]. Set to
[Enhanced] to support two SATA 6.0 Gb/s and two SATA 3.0 Gb/s devices. Set to
[Compatible] when using Windows 98/NT/2000/MS-DOS. Up to four SATA devices
are supported under these operating systems.
Configuration options: [Disabled] [Enhanced] [Compatible]
Serial-ATA Controller 1 [Enhanced]
This item appears only when you set the SATA Mode item to [IDE Mode]. Set to
[Enhanced] to support two SATA 3.0 Gb/s devices.
Configuration options: [Disabled] [Enhanced]
S.M.A.R.T. Status Check [Enabled]
S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitor
system. When read/write of your hard disk errors occur, this feature allows the hard
disk to report warning messages during the POST.
Configuration options: [Enabled] [Disabled]
4.5.5 PCH SCU SAS Configuration
The PCH SCU SAS configuration items appears only when you have installed the ASRK
Module (optional) on the motherboard.
Device1 Not Present
Device2 Not Present
Device3 Not Present
Device4 Not Present
→←: Select Screen
↑↓: Select Item
Enter: Select Item
+/-: Change Opt.
F1: General Help
F2: Previous Values
F5: Optimized Defaults
F10: Save & Exit
ESC: Exit
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Advanced
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.