Net Optics iBypass HD - Manual (Page 20)

16
iBypass HD
To connect the CLI locally over an RS232 serial port:
1. Connect a PC with terminal emulation software, such as HyperTerminal (or a Linux workstation running minicom),
to the iBypass HD using a network cable and a DB9 or USB serial adapter.
Computer with terminal
emulation software
RJ45 to DB9
adapter
Management Port
Console Port
Figure 10: Connecting RS232 Cable to the iBypass HD
2. Launch terminal emulation software and set communication parameters to:
115200 baud
8 data bits
No parity
1 stop bit
No flow control
The Net Optics CLI banner and login prompt are displayed in the Terminal Emulation software.
***********************************************************
* Net Optics Command Line Interface (CLI) *
* for the iBypass HD *
* *
* Copyright (c) 2008-2010 by Net Optics, Inc. *
* *
* Restricted Rights Legend *
* *
* Use, duplication, or disclosure by the Government is *
* subject to restrictions as set forth in subparagraph *
* (c) of the Commercial Computer Software - Restricted *
* Rights clause at FAR sec. 52.227-19 and subparagraph *
* (c)(1)(ii) of the Rights in Technical Data and Computer *
* Software clause at DFARS sec. 252.227-7013. *
* *
* Net Optics, Inc. *
* 5303 Betsy Ross Drive *
* Santa Clara, California 95054 *
* (408) 737-7777 *
* e-mail: [email protected] *
* *
***********************************************************
user login:
Figure 11: CLI sign-on banner