Net Optics iBypass HD - Manual (Page 16)

12
iBypass HD
Rack Mount the iBypass HD device
The iBypass HD is designed for rack mounting in a 19-inch equipment rack and occupies one rack unit.
To mount the iBypass HD device:
1. Attach a slide rail bracket to each of the slide rails.
Use either the short or long slide rail brackets, as needed to match the depth of your rack. The slide rail bracket is
placed over the two mounting studs and adjusted to the required length. The brackets can be attached with the short
leg ahead of or behind the mounting studs, providing greater span of length adjustment.
2. Mount the slide rails to the front and rear rack posts using the provided screws and washers.
3. Slide the iBypass HD into the slide rails.
The iBypass HD locks into place. Disengaging it from the slide rails requires depressing the locking latch.
Make sure that the rack is properly grounded.
Connect Power to the iBypass HD
Supply AC power to the iBypass HD using the power cords that were included with the unit; for DC power, you must
supply your own cables. If you plan to use redundant power, make sure that you connect the power supplies to two
separate, independent power sources for maximum protection. One or both Front Panel Power LEDs are illuminated,
depending on whether you used one power supply or two.
Note: __________________________________________________________________________________________________
Each AC or DC power source should be independent of the other in order to have power redundancy. If you do not
require power redundancy, the unit can be operated with a single power cord connected to a single AC or DC power
source. In this case, either AC or DC power connector on the rear of the unit can be used for the connection.
________________________________________________________________________________________________________
Use the procedures in the following sections to safely connect AC or DC power to the unit.