Draw-Tite 1040000 CARGO CARRIER - ECONOMY User Manual
Item: description

ITEM:
DESCRIPTION:
1040000N REV K 3-21-11
PRINTED IN CHINA
1040000
CARGO CARRIER 60” X 20”
Cequent Performance Products, Inc.
Plymouth, MI 48170
CONSUMER: Keep instructions and read before each use.
FIGURE 1.
DO NOT EXCEED LOWER OF: 500 LB LOAD CAPACITY – VEHICLE OR HITCH MFR’S TONGUE WEIGHT RATING
FIGURE 2.
Hex Bolt, 1/4” x 3/4”
12
Carriage Bolt, 3/8” x 3.00”
3
Hex Lock Nut, 1/4”
12
Hex Nut, 3/8”
3
Flat Washer, 1/4”
24
Flat Washer, 3/8”
3
Hitch Pin, 5/8” (part #55010)
1
Clip (part #55515)
1
End Plate
1
End Plate w/ Shank hole
1
Center Plate
1
Shank
1
Basket Frame
2
1.
Align both halves of the basket on the ground, attach each end plate to
the outside of the basket as shown in Fig 1 and fasten loosely with (12)
1/4” bolts, (24) 1/4” flat washers, and (12) 1/4” hex nuts.
2. Slide 2” shank through shank hole and align holes in end plates. Align center
plate on the inside of the basket with holes in shank and loosely attach
with (3) 3/8” carriage bolts, (3) 3/8” flat washers, and (3) 3/8” nuts.
3. Go back and tighten all hardware. Tighten all 1/4” hex bolts to 6 ft-lb and all
3/8” bolts to 24 ft-lb
1/4” flat washer,
1/4” hex nut (12
places)
1/4”x ¾” hex bolt,
1/4” flat washer (6 places)
End plate
w/ shank
hole
Center Plate
3/8” X 3.00” carriage bolt,
3/8” flat washer,
3/8” hex nut (3 places)
Shank
(1)
1/4”x ¾” hex bolt,
1/4” flat washer (6 places)
End plate