C.5 serial hub mode – SENA Parani-MSP100 User Manual
Page 59
59
Multiple Repeater Parani-MSP100s up to 7 can be connected to one Station Parani-MSP100, but
Repeater-to-Repeater connection (Multi-level repeater) is not allowed. Parani-MSP100 may operate
as “Station MSP” while it is either Server/Client/Vertex/Serial Hub/RS232 mode.
All you need to configure in Repeater is only Bluetooth device address of Station MSP and repeater
doesn’t need to have any network connectivity (Just power-supply).
C.5 Serial Hub Mode
In Serial Hub Mode, Parani-MSP100 relays data communication between Bluetooth devices. With
Parani-SD only 1:1 cable replacement is possible, however, incorporati ng Parani-MSP100 multiple
Parani-SDs can communicate each other, 1:N multi-serial with Parani-SD.
In Serial Hub mode, Parani-MSP100 handles data according to Route Table, which shows which data
frame should go where. Route Table needs to be configured in advance using Parani-MSP100
software.
In-Band Command
In addition to Route Table, user can specify the destination of the frame they send by inserting extra
Note:
When using repeater, overall data throughput can be lowered.
Multi-level repeater is not allowed.
Station MSP
Repeater
MSP