SENA Parani-MSP100 - Manual (Page 54)

54
as Inquiry scan and Page scan, then converts
the operation status to ‘Standby’
AT+SETESC Escape sequence character set to ‘+’ by
default is changeable. The parameter nn must
be a printable character.
AT+SETESC,42
AT+BTLAST? The Bluetooth device last connected to this
Parani-MSP100 is displayed with its BD
address.
AT+BTSEC If the authentication is activated, the pin code
must be set by AT+BTKEY command. Data
encryption cannot be used when
authentication is not enabled, i.e.
Authentication=0 and Encryption=1 will not
work properly.
AT+BTSD? Once a connection is made with a pin code,
Parani-MSP100 saves the Bluetooth device
with its link key, generated by the pin code.
The connection to a device listed in Parani-
MSP100 can be made automatically without
the authentication process. The maximum
number kept on the list is 5.
AT+BTCSD This clears the list of Bluetooth devices linked
with the same key in flash memory. To take
effect the ATZ command must be used or
Powercycle the unit.
AT+BTMODE When the operation status is ‘Pending’
currently, change the status to ‘Standby’ with
AT+BTCANCEL prior to this command.
To take effect the ATZ must be executed or
Powercycle the unit. Support only Mode 1 and
Mode 2. You can register Mode 1 devices by
using AT+BTREG.
S ※ -registers are not supported.
Following commands are appended to Parani-MSP100.
Command Description Example
AT+BTCHAN? Show currently selected device. AT+BTCHAN?