SENA Parani-MSP100 User Manual
Page 53
53
ongoing tasks. After rebooting, the status will
be decided by the preset operation mode.
Some
AT
commands
require
the
ATZ
command be run so that the commands can
take effect.
AT&F
This has the same effect as initialization by
pressing
the
factory
reset
button.
All
parameters are initialized to factory defaults.
ATD
Connectable up to 7 devices concurrently
ATH
Device to disconnect can be specified.
ath000b53123456
ATO
Device to communicate can be specified.
Without specified device, lately communicated
device will be selected.
Parani-MSP100 responds with CONNECT.
ato000b53123456
CONNECT 000B53123456
AT+BTSCAN
Scan mode can be specified.
1: Discoverable
2: Connectable
3: Discoverable and Connectable
at+btscan,3
AT+BTINQ?
The Bluetooth devices in Inquiry scan mode
nearby are displayed with their BD addresses,
Device names, and Class of device. Maximum
15 devices are scanned for 30 seconds.
AT+BTINFO?
The current Bluetooth settings are displayed
including BD address, Device name, Operation
mode, Operation status, Authentication, Data
Encryption, and Hardware Flow Control.
AT+BTNAME
Parani-MSP100 can have a user friendly name
for easy identification. The name allows up to
30 alpha- numeric characters.
AT+BTKEY
Pin code is a string, which allows up to 16
alpha-numeric characters. Based on this pin
code, Parani-MSP100 generates a link key
which is used in actual authentication process
AT+UARTCONFIG
The Serial parameters can be set or changed.
The factory default is 9600, N, 1.
To take effect the ATZ command must be used
or Powercycle the unit.
AT+UARTCONFIG,9600,N,1,1
AT+BTCANCEL
This terminates a current executing task, such