SENA Parani-MSP100 - Manual (Page 48)

48
DISC
: Parani-MSP100 may DISCONNECT forcibly by DISC command, giving
INDEX value in LIST command.
Ex.: LIST
0|0|5000|00:0B:53:00:00:8A|SDv3b-00008A|0|0
+OK
DISC 0
+OK
LIST
+OK
LINKTO
: When a Bluetooth device is disconnected by turning off its power, Parani-
MSP100 has default time out of 20 seconds in finally closing the
connection. You may assign the time out from 1 second up to 30 seconds.
Ex.: LINKTO 20
+OK
MAXDT
: To assign maximum Bluetooth devices concurrently connectable to
Parani-MSP100 ™ . Default value is 7. Each additional USB extension
module adds up to 7 more Parani-MSP100 ™ connectable Bluetooth
devices.
Ex.: MAXDT 7
+OK
PINQ
: If PINQ (periodic inquiry) is ON, Parani-MSP100 will inquire nearby
Bl uetooth devices periodically, by each seconds, for
time.
Note:
Parani-MSP100 normally acts as an acceptor. Do not use CONN
command in operating sequence as Parani-MSP100 will freeze during
CONN operation.
If using with Parani-SD, please configure Parani-SD as Mode 1 and make
it initiate connection to Parani-MSP100.