SENA ProBee-ZS10 - Manual (Page 62)

62 ProBee-ZS10 User Guide Rev.1.5
7.2.2 S22
Description
Get/Set the timeout to permit joining. It determines the time in seconds that the device
will allow other devices to join to it when it starts network but an end-device cannot
perform it. If set to 255, the device will always permit joining.
Execute ATS22? ATS22=
Response
OK
OK
Default 255
Range
0 - 255
7.2.3 S23
Description
Get/Set the power boost mode of the adapter. If enabled, boost mode improves
sensitivity by 1dB and increases output power by 2dB, improving the link margin and
range.
Execute ATS23? ATS23=
Response
OK
OK
Default 0
Range
0 – 1
7.3 Data Transmissions
7.3.1 S31
Description
Get/Set the application-ACK mode. If it is enabled, a sender node retransmits data
packet when it fails to receive ACK from receiver node. This value must be set same
on the source and destination node for data transmission.
Execute ATS31? ATS31=
Response
OK
OK
Default 1
Range
0 - 1
7.3.2 S32
Description
Get/Set the transmission retries. A sender tries to retransmit up to this value when
transmission fails. (CAUTION: It is recommended to set the smallest value that the
application can tolerate in broadcast/multicast data transmission. )
Execute ATS32? ATS32=
Response
OK
OK
Default 5