SENA ProBee-ZS10 - Manual (Page 51)

51 ProBee-ZS10 User Guide Rev.1.5
Range 0 - 4
5.7.6 AT+UNICAST or AT+UC
Description
Send unicast message to specific node using long or short address of remote node.
Up to 90 bytes (or 72 bytes when security enabled) are sent to the node at once.
Execute AT+UNICAST=, AT+UNICAST=,
Response OK
5.7.7 AT+MULTICAST or AT+MC
Description
Send multicast message to specific group. Every node belongs to the group after
being booted up if it is designated to a group ID (AT+GROUPID).
Execute AT+MULTICAST=,
Response OK
5.7.8 AT+BROADCAST or AT+BC
Description
Send broadcast message to the all nodes joining the network. Transmission range is
determined by broadcast range (S35).
Execute AT+BROADCAST=
Response OK
5.7.9 AT+REMOTE or AT+RC
Description
Get/Set the configuration values of remote node using long or short address.
AT+REMOTE shows the list of available commands.
Execute AT+REMOTE=,? AT+REMOTE=,=
Response
OK
OK
5.8 Security
5.8.1 AT+SECURITY or AT+SE
Description
Get/Set the security status. (0: turning security off, 1: on) Every node must be under
the same security level in the network.
Execute AT+SECURITY? AT+SECURITY=
Response
OK
OK or ERROR
Default 0
Range
0 - 1
5.8.2 AT+LINKKEY or AT+LK
Description Get/Set the 128-bit link key. (0 or 0s: generate 128-bit random number)