SENA ProBee-ZS10 - Manual (Page 53)

53 ProBee-ZS10 User Guide Rev.1.5
5.9.3 AT+PARITY or AT+UP
Description Get/Set the serial parity setting on the module.
Execute AT+PARITY? AT+PARITY=
Response
OK
OK or ERROR
Default 0
Range
0 - 2
5.9.4 AT+STOPBIT or AT+US
Description Get/Set the serial stop bit setting on the module.
Execute AT+STOPBIT? AT+STOPBIT=
Response
OK
OK or ERROR
Default 1
Range
1 - 2
5.9.5 AT+FLOWCTRL or AT+UF
Description Get/Set flow control status. (0: none, 1: software, 2: hardware flow control)
Execute AT+FLOWCTRL? AT+FLOWCTRL=
Response
OK
OK or ERROR
Default 0
Range
0 - 2
5.10 Firmware Upload and Help
5.10.1 AT+BOOTLOAD or AT+BL
Description
Start bootloader to upload firmware. (blank: local, 1: passthru, 2: clone)
The device leaves the AT command line and enters the bootloader menu for uploading
new ProBee firmware. There’s no restrict to use local upload but a sleepy end-device
cannot upload to remote node over the air. The current UART should be set
115200bps, 8 data bits, no parity, 1 stop bit and none flow control.
Execute AT+BOOTLOAD AT+BOOTLOAD=,
Response
Bootloader menu
…
Serial upload complete
Please start .ebl upload image ... or
Start cloning ...
Bootloader menu
…
Bootload Complete!