SENA ProBee-ZS10 - Manual (Page 11)

11 ProBee-ZS10 User Guide Rev.1.5
2 Getting Started
Creating a ZigBee network using the ZS10 adapters consists of the following steps:
• Connect a power source to the ZS10 adapter
• Create a ZigBee network by configuring a ZS10 adapter as the coordinator
• Configure ZS10 adapters as routers. This step is optional since the coordinator works as a router
too.
• Configure ZS10 adapters as end-devices
• Transmit data between ZS10 devices
This chapter describes how to install the ZS10 adapters and how to use terminal software programs to
access the ZS10 adapters using AT commands for configurations and operations. The rest of the steps
including ZigBee network creation, coordinator/router/end-device configurations and data transmissions
are described in the following chapters. The more detailed information on the panel and the configuration
examples are also provided in the later chapter.
2.1 Hardware Installation
2.1.1 Panel Layout
Figure 2-1 shows the layout of the panel. The panel provides the interface between the ZS10 and the
external serial port with input/output terminals for convenient tests.
Figure 2-1 Panel Layout of ZS10