SENA ProBee-ZS10 - Manual (Page 37)

37 ProBee-ZS10 User Guide Rev.1.5
OK # Response
Send unicast msg # Put the unicast message
+++ # Leave data mode
OK # Response
ATD0000 # Enter the unicast mode using 16-bit node ID
OK # Response
Send unicast msg # Put the unicast message
+++ # Leave data mode
OK # Response
ATD00019500002FDC40 # Enter the unicast mode using 64-bit IEEE address
OK # Response
Send unicast msg # Put the unicast message
+++ # Leave data mode
OK # Response
AT+DESTLA=00019500002FDC40 # Set the destination IEEE address
OK # Response
AT+TRANSMITMODE=1 # Set transmission mode to destination IEEE address
OK # Response
ATZ # Apply to change
OK # Response
Send unicast msg # Put the unicast message
+++ # Leave data mode
OK # Response
AT+TRANSMITMODE=4 # Set transmission mode to sink node in the network
OK # Response
ATZ # Apply to change
OK # Response
Send unicast msg # Put the unicast message
+++ # Leave data mode
OK # Response