S&B Filters Cold Air Intake Kit - Cotton Filter 75-5067D - Manual (Page 2)

15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbfilters.com
Installation Instructions (continued)
9.
Once all three latches are disconnected lift
the cover up and out to the side to remove.
12.
Once access is available to the side
inlet remove by pushing down on the tabs. A
screw driver may be required to loosen the 2
tabs on top and 1 tab underneath.
SEE EXPLODED VIEW ON PAGE 6
2
P/N: 75-5067 / 75-5067D
6.
Remove the top tube by pulling out and
away from the factory air box.
7.
Pull the rest of the factory intake tube out
by moving it to the side and lifting up. Note :
on some vehicles there is a hose from the
crank case that also must be removed.
10.
Remove the factory air filter.
11.
Remove the factory air box by removing
both bolts and lifting up on the box. The other
connections to the box do not need to be
removed to gain access to the side inlet.
8.
Remove the factory air box cover by
disconnecting the three metal latches that are
on the side of the factory air box.
13.
Install the S&B fender Inlet (X) by
pushing in firmly, wait until it snaps into place.
14.
After the S&B inlet is installed, lower the
factory air box back down and reinstall the
factory bolts. Make sure the S&B inlet
(X) is
pushed through the side skirt.
15.
Attach coupler (T) to intake tube (C)
using hose clamps (L) . Only tighten the hose
clamp on the S&B intake tube side while
leaving the other hose clamp loose.
16.
Attach coupler (S) to intake tube (C)
using hose clamps (M) . Again only tighten the
hose clamp on the tube side while leaving the
other hose clamp loose.
17.
Attach the hose clamp (O) to the intake
rubber cuff (R) .