Installation instructions (continued) – S&B Filters Cold Air Intake Kit - Cotton Filter 75-5061 User Manual
Page 2
15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 -
Installation Instructions (continued)
14.
If equipped with Pressure Sensor, Drill a
3/8” hole using the drill point located in the Filter
Adapter Tube
(Y)
. Be careful only to drill through one
surface (NOT all the way through the backside).
Thoroughly clean the inside of the tube of all
debris. Then install the pressure sensor using the
1/4-20 Socket Screw
(N)
and a 3/16” allen wrench.
17.
Install MAF sensor into the Intake Tube
(AA)
using the supplied 8-32x1/2” Screws
(P)
.
Do not over tighten.
2
18.
Install the 90deg. Hose Barb
(V)
on to
the Intake Tube
(AA)
until it is hand tight.
Then
using a 9/16” wrench turn it one more
rotation into position as shown.
20.
Secure the Silicone Step Coupler
(AC)
to the throttle body using a #64 Hose Clamp
(F)
. Place the #72 Hose Clamp
(G)
around
the top of the Silicone coupler.
SEE EXPLODED VIEW ON PAGE 4
P/N: 75-5061 / 75-5061D
19.
Place a #64 Hose clamp
(F)
over each
end of the Hump Coupler
(AB)
. Then slide
the hump coupler over the end of the Adapter
Tube
(Y)
. Tighten the clamp closest to the air
box.
10.
Using 10mm socket, remove the four
screws securing the air box mounting tray.
13.
Using the supplied T15 Torx Key,
remove the MAF sensor from the OE air box.
If Equipped, remove the pressure sensor as
well.
12.
Move the coolant reservoir out of the way.
Install the Air Box
(A)
using the two supplied
M6x30mm screws
(C)
and 6mm Washers
(B)
for
the two holes closest to the fender. Use the OE
screws for the other two holes. Tighten all four.
11.
For those concerned about minimal engine heat; insert the four Clip Nuts
(S)
over the holes on
the bottom opening of the Air Box
(A)
, insert the Box Plug
(T)
into the end of the Air Box
(A)
. Attach
using the supplied 1/4-20 Hex Screws
(U)
and Flat Washers
(B)
from the inside of the Air box using
5/16” socket or ratcheting wrench. For those seeking additional air flow, set the Air Box End Cap
aside and save all the supplied hardware.
(See page 3 for more info)
O
E
Scre
w
s
15.
Place the Adapter Tube
(Y)
into the base
of the S&B Air Filter
(D)
and tighten the #80
Hose clamp
(E)
.
16.
Install Filter/ Adapter assembly into the
Air box.