S&B Filters Cold Air Intake Kit - Cotton Filter 75-5040 - Manual

1. With the ignition switched off and the
parking brake set, disconnect the negative
battery cable on the driver’s side.
Installation Instructions
Vehicle Application
Year: 2003-08
Make: DODGE/ RAM
Model: 1500
Engine: 5.7L Hemi
15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbfilters.com
5.
2004-08 Models: Remove the breather
hose from the lid of the air box only.
2003 Models: Remove the breather hose
from the oil fill reservoir.
8.
From inside the engine compartment,
carefully pull the wiring harness connector out
from the wheel liner. Then remove the wheel
liner from the truck.
6.
Remove air box by carefully pulling the air
box straight up out of the four pins of the air
box tray. Then remove the two bolts
mounting the tray to the frame using 13mm
socket.
9.
Using 13mm socket, remove the other 2
bolts securing the air box tray. Then remove
the tray from the truck
2.
Loosen the hose clamp connecting the
tube to the air box and the clamp attaching
the tube to the resonator body. Then remove
intake tube from the truck.
7.
Remove the eight screws securing the
wheel liner using 8mm socket.
P/N: 75-5040 / 75-5040D
SEE EXPLODED VIEW ON PAGE 4
1
Tools Required
• 8mm, 10mm, 13mm Wrench & Socket
• 7/16” Wrench and Socket
• 5/16” Nut Driver or Flat Blade Screwdriver
• Phillips Screwdriver
Notes
Kit may not fit with the following
Aftermarket Parts installed:
• Body Lift or Lowering Kit
• Custom Hood
• Throttle body upgrades
S&B Filter Maintanence
Cleanable (KF-1056) . If the enclosed filter is Red, it came pre-oiled
from the factory. When serviced, apply (110g) of S&B oil to the
main body of the filter and (20g) to the Power Stack (Top).
Disposable (KF-1056D) . If the enclosed filter is White, it is a
disposable filter and should be discarded once it reaches capacity.
This filter
(does not require oil) . For more info on S&Bʼs disposable
filter, visit www.sbfilters.com .
Before You Start
• Please read the entire product guide before proceeding.
• Ensure all components listed on page 4 are present.
• If you are missing any of the components, call our customer support at (909) 947-0015.
• Do not work on your vehicle while engine is hot.
• Make sure the engine is turned off and the vehicle is in Park or the Parking Brake is set.
3.
Loosen the two screws on the resonator
assembly using a 10mm socket.
Disconnect the Temp. Sensor wiring harness
from the sensor.
4.
Remove the OE throttle body gasket.