Installation instructions (continued), Crow foot calculation – S&B Filters Intake Elbow 76-1004 User Manual
Page 3
EMISSIONS STANDARD
The California Air Resource Board (CARB) requires that an E.O. identification label be applied to the vehicle in order to pass a smog
check inspection when a Performance Intake Kit has been installed. You must place the E.O. label provided on or near the intake kit
after installation so that a smog check technician can easily verify the E.O. number. As of April 2009, S&B has never had a product
where CARB denied an exemption request; however, the exemption process with CARB can take as long as 18 months. Check the
status of the exemption process by looking up a specific part number at
The CARB Exemption number and/or
status is listed under the Product Details section for each part number. If the status shows as “Pending,” CARB has yet to issue an
exemption. Products that have not been issued an EO number are street legal in most states, but may not be used on emission
controlled vehicles in the state of California and are for off road use only. If you purchased your kit from S&B Filters directly, we will
automatically mail you your Exemption Sticker when it is issued to us. If you purchased your kit from an authorized S&B Filters Dealer,
log onto our web site and register to receive your Exemption Sticker.
15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 -
INSTALLATION INSTRUCTIONS (Continued)
PERFORMANCE TESTING
• Engage parking brake and start your engine.
Listen for abnormal noises. If an air leak is
detected, re-inspect hoses and connections as
they may need to be repositioned and
tightened.
• S&B FILTERS recommends that you keep
your OE intake elbow in the event it is
required in the future.
• In order to maintain your warranty, all
connections and components must be
checked periodically for alignment and for
proper tension on all connections. Failure to
do so may void your warranty.
SEE EXPLODED VIEW ON PAGE 4
3
P/N: 76-1004
RELATED ITEMS FOR YOUR
PURCHASE
• Cold Air Intake System (S&B P/N: 75-5047)
• Ram Air Scoop (S&B P/N: 75-5049)
• Heater Delete Block (S&B P/N: 76-1005)
20.
Use the supplied Zip-tie
(L)
to secure the
wiring harness behind the elbow that was
removed in Step #4.
21.
Reconnect both batteries. Inspect your
installation, make sure the kit is properly
positioned and all fasteners are secure. Affix
the CARB sticker near the intake kit. The
installation is now complete.
Crow Foot Calculation
NOTE: This is a calculation to adjust your
Torque Wrench for use with a Crow Foot
attached. Please note the end value will never
be higher than the original torque value.
19.
Secure the dip stick tube upper bracket to the Elbow. Apply thread locker to the 5/16” x 1/2”
Bolt
(B)
. Then place the Flat Washer
(A)
on the 5/16” x 1/2” Bolt
(B)
. Place the bolt and washer
through the upper bracket and place the Rubber Washer
(M)
and the other Flat Washer
(A)
under
the bracket and thread the bolt into the elbow and secure. Do not exceed 30 In. lbs. If applicable, re-
attach the dipstick bracket to the stud that was removed in step #14.