Powersolve SM800 Series - Manual (Page 5)

SM800
May 2013 SPECIFICATIONS Page 1 - 5
Typ i cal Ap pli ca tions
• Accurate current sources • Automotive battery simulation • Driving PWM-controlled DC-motors
• Electronic circuit development • Controlled battery (dis)charging • Medical research equipment
• Component device testing • Lasers • Aerospace and military equipment
• ATE in industrial production lines
In creased
Out put Power
The conservatively rated unit
allows to deliver extra output
with the same reliability.
At some derating, either the maximum output
voltage or the maximum output current can be
increased by about 10%.
• Order Code - P069
Avail able Op tions
High speed
pro gram ming
A 10 to 20 times higher
programming speed (down to
0.2 ms rise time at full load)
and lower output capacitance.Excellent for
laser applications, test systems or as current
source with low parallel capacitance as used
in plasma chambers.
• Order Codes :
SM 7.5-80 P250 - SM 70-AR-24 P252
SM 18-50 P251 - SM 400-AR-4 P253
Two-Quad rant
Out put: Power sink
Two quadrant operations
maintains the output voltage
constant regardless the
output power is positive or negative. Ideal for
PWM-speed controlled DC-motors and ATE
systems.
• Order Codes :
SM 7.5-80 P245 - SM 70-AR-24 P247
SM 18-50 P246 - SM 400-AR-4 P248
Sequencer
Arbitrary Waveform generator
or standalone automation.
The se quencer is in te grated in
the Ethernet con trol ler.
• Order Code - P256
High Volt age Isolation
A higher output isolation
allows series operation up to
1000V
• Order Code - P089
Se cured Volt age
and Cur rent Set ting
For a maximum security,the
CV/CC settings can be
adjusted with a screwdriver
only and are protected with a plastic cap from
accidental adjusting.
• Order Code - P001
Soft ware con trol
and in ter faces
Factory installed programming
interfaces:
• ISO AMP Card - isolated analog - P249
• RS232 controller - P254
• IEEE488 controller - P255
• Ethernet controller (incl. sequencer) - P256
• PROFIBUS controller - P271
• CANBUS controller - P272
0,4ms
Dig i tal Volt age
and current set ting
Reliable, long life digital
encoders are implemented at
the front panel.
Includes total front panel lock (also for
CV/CC-knobs) and a coarse or fine pitch
adjustment depending on the turning speed.
• Order Code - P236
Front Power Out put
Blind posts at the front panel
instead of at the rear panel.
• Order Codes :
SM 7.5-80 n.a. - SM 70-AR-24 P258
SM 18-50 P257 - SM 400-AR-4 P259
19" Rack
Mount ing Adapter
The 19" mounting adapters
makes it possible to
position one or two units
side by side in a 19" rack.
• Order Code RA19 - 2SM800
Note: 1. Down load spe cial datasheet about High Speed Pro gram., Power Sink and Bat tery Charg ing from
www.powersolve.co.uk
2. There is only room for one of the in ter faces in a unit (P249, P254, P255, P256, P271 or P272).