Powersolve PSDE65 Series - Manual

Powersolve Electronics Ltd. 8A Arnhem Road, Newbury, RG14 5RU. England
Tel: 01635 521858 Fax: 01635 523771 Email: [email protected]
Desk Top Power Supplies
PSDE36-65 Series
36 to 65 Watts Switch Mode
Input Voltage Range 90-264VAC
Input Current 1.5A max.
Frequency 47-63Hz
Isolation - Input/Output 3000VAC
Leakage Current 250µA max. at 240VAC 60Hz
Insulation Resistance >100M Ohm/500VAC 10mA for 1 minute between primary & secondary
Hi-Pot Test 4.242kV between primary & secondary for 1 second
DC Output see table
Output Connector Type Standard -02 variant, 2.5 x 5.5 x 11mm barrel type, others connectors optional
Load Regulation ±5%
Ripple & Noise 1% Vout max
No Load Standby Power ≤0.5W
Efficiency minimum 87% at active average load to conform with CEC level V requirements
Hold-up Time 12ms minimum at 115VAC 60Hz
Turn On Delay 5s max.
Overshoot 8% max.
Short Circuit Protection continuous, auto-recovery after fault removed
Over Voltage Protection output will shutdown, recycle input to recover
Over Current Protection self limiting auto recovery
Over Temperature Protection output will shutdown and latch
Operating Temperature Range 0 to +40°C
Storage Temperature Range -20 to +85°C
Humidity 10 to 90% RH, non-condensing
Safety Approvals CE, GS, UL, cUL
EMC EN55022 class B, FCC 15 class B, CISPR 22 class B
MTBF Figures >280,000 Hours to MIL-HDBK-217F(Notice 2)
Mechanical see drawing
Electrical Specification
Features
• Universal Input Range 90-264VAC
• Continuous Short Circuit Protection
• Over Voltage, Over Current & Over Temperature Protection
• Operating Temperature Range of 0 to 40°C
• No Load Power Consumption ≤0.5W max
• Meets CEC Level V Energy Saving
• Class II Safety
www.powersolve.co.uk
MODEL OUTPUT VOLTAGE OUTPUT CURRENT MAX POWER
PSDE36-09-(XX) 9.3V DC 4.0A 36 Watts
PSDE60-12-(XX) 12V DC 5.0A 60 Watts
PSDE65-18-(XX) 18V DC 3.6A 65 Watts
PSDE65-19-(XX) 19V DC 3.42A 65 Watts
PSDE65-20-(XX) 20V DC 3.25A 65 Watts
PSDE65-24-(XX) 24V DC 2.7A 65 Watts
Output Voltage & Current Ratings
NOTE: (XX) in part number denotes output connector type. Standard stock items have 2.5 x 5.5 x 11mm centre positive barrel
connector. Therefore part number would be PSDE60-12-02. Other connectors are available which would be a different 2 digit number,
consult sales office for details.