Powersolve HSEUIreg07201 Series User Manual
Page 9
Powersolve Electronics Ltd., Unit 8A Arnhem Road, Newbury RG14 5RU, United Kingdom
Tel 0044 (0)1635 521858 Fax 0044 (0)1635 523771
www.powersolve.co.uk
p.9/9 05.12D
(Subject to alterations. This product is not designed to be used in applications such as life support systems wherein a failure or malfunction could result in injury or death)
Safety Instructions:
Please read all warnings and advices carefully before installing or operating the HSEUIreg. Retain this operation manual always
ready to hand.The HSEUIreg must be installed by specialist staff only.
Installation:
1.)
The HSEUIreg is designed for systems fulfilling the safety norms of
dangerous voltages/energy and fire prevention
2.)
Installation is restricted to specialists only, make sure that the AC
wire system is free of voltage
3.)
Opening the HSEUIreg, making any modifications to it, dismounting
any screws from it, operating the HSEUIreg out of specification
and/or using it in appropriate area will unevitably result in loosing
manufactureres guarantee; we decline taking any responsibility for
risk of demages caused to someones health or to any installed
system.
4.)
Attention: The HSEUIreg has an internal input fuse. It is necessary
to wire an automatic circuit braker to the line. We suggest to use a
16A-type with B-characteristic. It is verboten to operate the
HSEUIreg without protective earth wired. It essential to install a line
switch before the HSEUIreg.
Warnings
:
Disregard these warnings can cause fire, electic shock, serious
accident and death.
1.
Never operate the HSEUIreg without Protective Earth
Conductor
2.
Before connecting the HSEUIreg to the AC wire system
make all wires free of voltage and assure accidently
switch on
3.
Allow neat and professionel cabeling
4.
Never open nor try to repair the HSEUIreg by yourself.
Inside are dangerous voltages that can cause electric
shock hazard.
5.
Avoid metal pieces or other conductive material to fall into
the HSEUIreg
6.
Do not operate the HSEUIreg under damp or wet
conditions
7.
It is verboten to operate the HSEUIreg under Ex
conditions or in Ex-Area
All parameters base on 15 minutes run-in @ full load / 25°C / 230Vac 50/60Hz, as otherwise stated.