Duro-Last Fascia System - Manual

Duro-Last: The Proven Performer®
"Duro-Last" and The "World's Best Roof" are registered marks owned by Duro-Last , Inc.
DATA SHEET
www.duro-last.com 800-248-0280
DURO-LAST ® FASCIA SYSTEM
Description:
The Duro-Last® Fascia System may be used as
perimeter detail for the Duro-Last roofing system and
as termination on rectangular penetrations. The system
consists of a bar and snap-on cover. The system has
been approved by FM Approvals as a Class 1-90
perimeter flashing.

The fascia bar is fabricated from rigid exterior vinyl
with pre-punched slotted holes 6 inches (152 mm)
on center. The bar is 10 foot long and available in
two widths: 1.75 inch (44 mm) and 4 inch (102 mm).
The bar is only available in white color.

The fascia cover is fabricated from rigid exterior
vinyl and is available in white, gray and tan colors.
The cover is 10 foot long and available in two
widths: 1.75 inch (44 mm) and 4 inch (102 mm).
(Note: If a metal cover is needed refer to the Metal
Fascia System Product Data Sheet.)
Material Safety Data Sheet:
Product Identity: Duro-Last 10 Foot Extrusions
Installation:
1. The 1.75 inch (44 mm) wide fascia bar must be
fastened 6 inches (152 mm) on center, maximum.
2. The 4 inch (102 mm) fascia bar must be fastened
6 inches (152 mm) on center, maximum. The
fastening may be along one row of holes or
staggered along three rows.
3. It is required to leave a ¼ inch (6.3 mm) gap
between sections of the fascia bar.
4. The fascia cover should be installed so that the
joints between sections are offset a minimum of 12
inches (25 mm) from the joints between sections of
the fascia bar.
5. It is required to leave a 1 in ch (25 mm) space
between sections of fascia cover.
6. Cover the gap between sections of fascia cover with
the fascia cover clip.
7. Apply Duro-Caulk® Plus along the top of the fascia
bar.
8. Refer to detail drawings 3030 and 3040 for
installation information when roof system is
mechanically attached or FA3030 and FA3040
when the roof system is fully adhered.
9. The fascia system may not be installed as a
gravel/water stop.
10. All vertical applications require Duro-Caulk Plus be
applied on both sides of fascia bar.
Note:

Fascia bar and cover are ordered separately in 10
foot lengths. They will be packaged in cardboard
tubes or boxes.

One joint clip will be included with each length of
cover. If the bar will be cut into smaller sections
additional joint clips may need to be ordered.
Revised: 7/2/2012
1.75 inch (44 mm) wide Fascia System
(Install per detail drawing 3030 or FA 3030)
4 inch (102 mm) wide Fascia System
(Install per detail drawing 3040 or FA3040)