Duro-Last Snap Coping - Manual

DATA SHEET
Snap Coping
“Duro-Last” and “EXCEPTIONAL” are registered marks owned by Duro-Last Roofing, Inc. Revised 8/30/2012
Description:
The snap coping offers a complete finish to any parapet
wall. The system utilizes 16-gauge cleat segments spaced
at 5’ – 0” centers.
Fabricated in 10 foot lengths; widths are
customized to specification.
16” cleat segments are fabricated in 16 gauge
galvanized.
6” Concealed splice plate eliminates exposed
fasteners and allows for thermal movement.
Riveted inside and outside miters and end caps are
available.
Contact Duro-Last
®
or EXCEPTIONAL
®
Metals to request
a color chart, samples and information regarding custom
metals and finishes.
Energy Efficiency:
LEED
®
and ENERGY STAR
®
compliant; Recyclable.
Installation:
1. A wood nailer attached to the top of the parapet
wall is required.
2.
This nailer should be attached to the wall in
accordance with ANSI/SPRI ES-1 3.9.
3.
Install the Canted Coping in accordance with Duro-
Last detail drawing #6054 and #6054 installation.
4.
Any deviation from the requirements set forth in the
detail drawings must be pre-approved, in writing, by
the EXCEPTIONAL Metals Technical Department.
Codes and Standards:
ANSI/SPRI ES-1 Compliant up to 16” width.
Meets TAS 111-95 Test with 12” wall dimension
and 4” face with 3” back.
Warranty:
Duro-Last offers a wide range of warranty coverage for
EXCEPTIONAL Metals products when used with the
Duro-Last roofing system, including paint and finish.
Technical Services:
Product samples, detail sheets, color chips, and color
chart are available for your submittal package. For
assistance with questions or submittals, contact your
local representative or call EXCEPTIONAL Metals.
Material Gauge Finish
Aluminum .032 Mill or Kynar ®
Stainless Steel 24-gauge N/A
Bonderized Steel 24-gauge N/A
Galvalume 24-gauge Mill or Kynar ®