Duro-Last Arched Drip Edge - Manual

DATA SHEET
Arched Drip Edge
“Duro-Last” and “EXCEPTIONAL” are registered marks owned by Duro-Last Roofing, Inc. Revised 9/05/2013
Description:
The Arched Drip Edge provides a smooth finish that is
an aesthetically-pleasing alternative to traditional
piecing. Vinyl-coated roof flange enables welding a
separate skirt to both the flange and the installed roof
membrane to provide a watertight seal.

Manufactured from various metals (see chart
below).

Made in 5’ to 10’ lengths depending on building’s
arch specifications.

Edges are pre-notched for overlapped joint.

Profiles can be custom-fabricated to meet most
specifications.

Hemmed drip kick to receive splice cleats.
Contact Duro-Last ® or EXCEPTIONAL ® Metals to
request a color chart, samples and information
regarding custom metals and finishes.
Energy Efficiency:
LEED
®
and ENERGY STAR
®
compliant; Recyclable.
Installation:
1. A wood nailer is required if 1” or greater of
insulation is used.
2. This nailer should be attached to the wall in
accordance with ANSI/SPRI ES-1 3.9.
3. Install in accordance with Duro-Last detail
drawings #6010 and #6040.
4. Any deviation from the requirements set forth in
the detail drawings must be pre-approved, in
writing, by the EXCEPTIONAL Metals Technical
Department.
Warranty:
Duro-Last® offers a wide range of warranty coverage
for EXCEPTIONAL Metals products when used with the
Duro-Last roofing system, including paint and finish.
Technical Services:
Product samples, detail sheets, color chips, and a color
chart are available for your submittal package. For
assistance with questions or submittals, contact your
local representative or call EXCEPTIONAL Metals.
Material Gauge Finish
Aluminum .032 Mill or Kynar ®
Stainless Steel 24-gauge N/A
Bonderized Steel 24-gauge N/A
Galvalume 24-gauge Mill or Kynar
®